Using the utility saw, cut a hole in the top and bottom of the first “body” pumpkin. One hole should be about fist-size, in order for you to reach your hand in and remove the seeds, and the other just big enough for a string of lights to pass through.
Hollow out the insides of the pumpkin with the scoop.
Drill a series of holes into the sides of the pumpkin, varying the size of the bits. When drilling the larger holes, you don’t have to puncture all the way through the flesh; the light will glow through partly drilled holes. Repeat with all pumpkins except for the head.
Set the pumpkin head on its side, so that the elongated shape can form the jaw of the snake. Draw a serpent face with long fangs around the stem of the pumpkin (which you should remove when you cut out the mouth), using a felt-tip marker. Cut out the eyes and mouth with the small saw. With a fine-tip utility knife, carve out other snake features, such as nostrils.
Once you have cleaned and drilled all your pumpkins, arrange them in a snaking line.
Starting with the head (which should be farthest from the house), pass the string of lights through the holes at each end of the pumpkins (the larger pumpkins may require two to three lights; the smaller pumpkins near the tail, just one). You may need an extension cord to reach an electrical outlet. – Martha Stewart
1 comment so far ↓
Greetings! Very useful advice within this post!
It is the little changes that produce the
biggest changes. Thanks for sharing!
Leave a Comment